Topside Control Repair in the Tri-Cities
A blank or flickering topside panel does not always mean a dead board. The ribbon cable, the overlay membrane, moisture under the lens and a failed pack output each produce the same symptom, and only one of them costs a new topside.
We isolate the panel from the pack, test each side, and replace only what has failed — often a cable or an overlay rather than the entire control.
Symptoms that bring us out
Display blank, spa still runsGhost buttonsOne button deadFlickering or dim segmentsPanel dead after a refillWrong readings on the screen
Hard water, city by city
Kennewick and Pasco draw from the Columbia at roughly seven grains; Richland tests around 11.5 grains — among the hardest in the state; West Richland and Benton City run on wells that are harder still, and Finley varies lot to lot. Scale is a factor in nearly every topside control job we do, so every visit includes a look at what the water is doing.
Topside Control by city
Topside Control in KennewickTopside Control in RichlandTopside Control in PascoTopside Control in West RichlandTopside Control in Benton CityTopside Control in Finley
Brands we repair
Questions we hear
Why does moisture get under the lens in the Tri-Cities?
Freeze-thaw and sprinkler overspray both drive water past the gasket. We reseal the panel edge on every topside job.
Do you carry topside panels?
Common Balboa TP and Gecko in.k panels ride with us; brand-specific topsides are a next-business-day part.
